Over on YouTube Leif (sm5bsz) has uploaded a video where he compares the Airspy HF+ with the Airspy+Spyverter combination. In the test he compares the two radios at 7 MHz. The signals come in from an antenna, are amplified and then passed into a notch filter which notches at 7.198 MHz. The antenna signal is then passed into an attenuator, and then through a directional coupler and then split into the two radios. A signal generator is used to inject a signal via the directional coupler at the notch frequency, and this signal is used to compare the two radios. This method stops antenna noise from appearing at the notch frequency and so any non-linearities appearing in the notch must be a problem with the radio.
The results that Leif finds are quoted below. They show that although the Airspy HF+ has good linearity, it can still be significantly improved in tough environments by adding a front end filter for the band of interest.
The Airspy HF+ and the Airspy+Spyverter are compared on 7 MHz with and without a band pass filter on the input. Without the filter the HF+ is a little better than the Airspy+Spyverter combo, but when the filter is inserted, the HF+ is MUCH better than the combo.
In an earlier video Leif also compares the two Airspy units on FM broadcast and the 2 meter band. Again he shows that the Airspy HF+ is better than the standard Airspy, but adding a filter to block out the broadcast FM can still help fairly significantly when trying to listen to the 2M band on the HF+.
The post Leif Compares the Airspy HF+ with the Airspy+Spyverter Combo appeared first on rtl-sdr.com.